Comments
-
Hi, "What do you mean by "BGP assigned public IP address"?" - I mean to bind VPN policy to one of available IP address from BGP pool which I advertise to my ISP. and your guess is right, but I hope that your answer is wrong (unfortunately this hope is small and poor) but I'm still fighting. anybody other ideas. DNAT -->…
-
@DesertSweeper in deed there is no magic here. But... there is always any kind of but... At the beginning sorry for using trival/simple terms... you have to consider on 2 levels: HA of WAN - in short words be prepared for one of ISP failure HA of Sonicwall device. so IMHO goal is to have ability to utilize both Wan links…
-
I already tried to contact support regarding the case… but they didn’t convince me. Rather I had impression that they didn’t quite understood my problem. (I didn’t had luck to reach us support, but far far east :-) if you know what i mean). Bound to ZONE Wan is only valid setting for site2site (it is not possible to set it…
-
You are doing it very similar. You have to make firewall Acl Wan-> DMZ/Alan Like: From any To 70.100.20.14 Service (up to you) Allow Than Nat Source any (or not? If you have white list for the service) Translated original Dest 70.100.20.14 Translated 192.168.1.14 Service any/specific (best practice to correspond to ACL.)…
-
@TKWITS you're right. ip address are just an example. I could use A.B.C.D. I know that BGP on sonicwall is only by CLI. The real question is: Does anyone know how to bind VPN policy (either tunnel interface or site2site) to BGP IP address. As far as I was able to dig in, sonicwall allows to bind VPN to an IP address which…
-
Hi, good idea is to separate devices into different zones and/or VLANs as it was mentioned by @Ajishlal just to clarify possible Setup: X0 LAN (zone LAN) for trusted ethernet connected DEVICE X0:VLAN17 (zone LAN) for trusted Wifi Device (just add tagged vlan 17 port on switch where your AP is connected - and assign…